|
| NOT ACTUAL IMAGE Associated with this RFQ
|
MFG.com is the global marketplace for the manufacturing industry. With over 100,000 members world-wide, no other marketplace even comes close.
Looking for Contract Manufacturers?
Get Online Quotes from Contract Manufacturers
Contract Manufacturer looking for customers?
Quote RFQs for Electronics Now
|
|
|
|
A buyer located in Little Mountain, South Carolina United States  successfully sourced for the Electronics of a part called Sync Cruise pad on www.MFG.com
Request for Quote Details:
 |
The specific Electronics process that was specified is Electronic Controls. |
|
The specified material is Electronic. |
|
This RFQ was for 500, 1,500, and 2,500 Each. The estimated annual usage is 1,500. |
RFQ Notes:
Below is what the electrical requirements are for the
cruise and sync pad for a boat dashboard. The switches
need to be of high quality and waterproof. The smaller the
unit the better, as long as it is very usable, meaning you
wont be hitting two switches at the same time. Something
to mount in a 2 hole is preferable.
(1) Switch RPM Mode ON = Ground; MPH Mode ON = 12
volts; and System OFF = open
(ground or 12 volts needs to be constant)
(1) Switch Set = 12 volts; Cancel = ground (12 volts
and ground are momentary signals)
(1) Switch Speed Increment = 12 volts; Speed Decrement
= ground (12 volts and ground are momentary signals)
(1) Switch Synchronization ON = ground; Synchronization
OFF = Open (ground is a constant signal)
(1) Bulb Cruise Status Lamp (unit supplies 12 volt to
bulb, the ECM will provide the ground)
(1) Bulb Sync Status Lamp (unit supplies 12 volt to
bulb, the ECM will provide the ground)
This is a total of (4) switches and (2) bulbs.
The following connector and pinout should be used. The
connector needs to be a Deutsch 12-Pin Plug (DT06-12S),
with the following pinouts.
1 = empty
2 = empty
3 = Synchronization Status Lamp
4 = empty
5 = empty
6 = empty
7 = empty
8 = Cruise Status Lamp
9 = Speed Increment/Decrement
10 = Cruise Set/Cancel
11 = Cruise Mode (RPM/MPH)
12 = Synchronization
This lead can be 12 long.
The power and ground wires, supply to the switches, can be
unterminated at 36 in length for various applications.
Please contact buyer with any questions.
This RFQ was awarded online at www.MFG.com to a Contract Manufacturer in East Hartford, Connecticut United States .
The annualized value of this RFQ was $63,125 USD to a Contract Manufacturer who is a member of the www.MFG.com service.
About MFG.com
MFG.com is an online marketplace servicing the manufacturing community. Headquartered in the United States, MFG.com instantly and intelligently matches buyers with suppliers of manufactured parts across the globe, greatly expanding business opportunities for both. MFG.com is transforming the once-fragmented world of manufacturing into a single, on-demand service, enabling products to be sourced and built more easily, quickly, inexpensively, and at higher quality levels. For more information, please visit www.MFG.com.
|
|
|
